Washtech XP Service Manual download pdf (Page 14)

XP Operating Instructions

Start up

Fit drain upstand, wash pump filter,

scrap tray and shut door.

Turn wall power switch on and select

any cycle (1, 2 or 3).

Power light glows red and machine

fills automatically.

Wash Ready light (water symbol)

glows amber when wash tank is

ready.

Rinse Ready light (tick symbol) glows

amber when the machine is up to

required temperature

Operation

Select required cycle (1, 2 or 3 for

1, 2 or 3 minute cycle accordingly).

Try cycle 3 initially and switch to

faster cycles only if necessary.

Load rack into machine and close

door to start the machine.

Cycle light glows green while

machine operates.

When Cycle light goes out, cycle is

complete

NOTE: Machine might operate

longer than specified above if hot

water supply temperature is below

required.

After removing rack from

machine, DO NOT shut door as

machine will start up again.

Shut down every night

Turn machine and wall power switches off.

Remove drain upstand to drain wash tank.

Remove scrap tray and wash pump filter and rinse clean.

Replace drain upstand, filter and scrap tray.

Service Manual XP-2

Revision 1C

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

No comments

Washtech XP Service Manual Page 14