Washtech UL User Manual download pdf (Page 62)

62

Trough 1

Deep trough section for racking and pre-

rinsing of soiled dishware on the inlet

to the machine. High back for splash

protection and scrap filters fitted.

Side Load Table 2

For automatic machine loading, a special

pawl bar table positioned at the load end

of the machine for single rack loading in a

corner situation. Standard length 730mm.

Available to operate in either direction:

left-right or right-left.

Power Curve - Pawl Drive 3

Machine driven 90° or 180° power curve for

use when space is at a premium. Racks are

loaded or unloaded from the machine and

turned within 850mm.

Roller Table 4

Usually fitted to machine outlet to reduce

load on machine drive and facilitate

faster drying with good airflow through

racks. Available curved, and hinged where

required for access. Standard lengths are

multiples of 500mm. Fitted with wastes

for easy cleaning.

Limit Switch 5

An accessory to the roller table, the limit

switch pauses the machine when the

outlet is fully loaded to prevent over-

loading the drive motor and avoids rack

jamming. On removal of racks the machine

restarts, an essential requirement in a busy

kitchen environment.

Driers 6

Driers are available in 600mm or 1200mm

modules up to 18kW.

Heat Recovery 7

The Heat Recovery unit extracts heat from

air exiting the machine and utilises this to

heat incoming water, reducing the overall

energy consumption of the system.

CD150 SYSTEM EXAMPLE

Circle of

operation

SCRAP

STORE

PLATEUSED

UNLOAD

SORT

SORT

RETURN

RACKS

SET-

DOWN

TRANSPORT

BUS

WASTE RINSE

DRY

RACK WASH

SERVE

PRE-RINSE

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 68

Comments to this Manuals

No comments